Auto report 3-18, Label format 3-18, Auto report – HEIDENHAIN ND 1200T User Manual

Page 70: Label format

Text mode
Original mode

Chapter 3

Setup

3-18

Auto Report
When yes is selected in this field tool sequence reports are auto-
matically printed at the end of a tool sequence run. If no is se-
lected the TC200 will prompt the user ‘Print tool sequence re-
port?’ This option selection field requires the supervisor pass-
word to be entered prior to access.

Label Format
Press the list softkey to access the format list. Use the up or down
arrow keys to select a report format. Press finish to return to the
label format setup screen. This option selection field requires the
supervisor password to be entered prior to access.