HEIDENHAIN ND 100 User Manual - Manual (Page 69)

ND 120 QUADRA-CHEK 69
2
.2
S
o
ft
wa
re
s
e
tu
p Order of setup
The setup software is contained on up to 18 screens, depending on
the hardware configuration. It is possible that not all the setup screens
described in this chapter are active in your system. Disregard screen
descriptions that do not apply to your DRO.
The initial setup tasks should be performed in the order listed here.
Instructions are presented in this order on subsequent pages.
The additional setup tasks can be performed in any order.
Setup configurations can be saved to a computer using USB-to-Serial
connection.
Initial setup tasks Setup screens
1: Language selection, axis configuration and product version information About
2: Supervisor password entry Supervisor
3: Encoder configuration Encoders and Misc
4: Loading settings data (instead of manual setup) Supervisor
5: Stage squareness calibration Squareness
6: Error correction LEC, SLEC or NLEC screen
7: Measurement scaling for parts that expand or shrink Scale factor
8: Measurement configuration Measure
9: Display formatting Display
Remaining setup tasks Setup screens
Hot key assignments Hot keys
Print formatting Print and Form characters screens
Saving settings Setup screens
Saving settings data Supervisor