HEIDENHAIN ND 100 User Manual - Manual (Page 24)

24 1 Operation
1
.2 Basic F
unctions
Display modes and soft key layout
DRO screens display information in one of four operating modes:
 DRO mode displays current positions of axes
 Feature evaluation mode screens can be toggled between two
displays that show all measurement results and the data cloud of
collected points
 Feature measurement mode displays feature type, points
collected and current positions of axes during measurements
 Setup mode displays installation and setup screens
Soft keys change to support activities shown on the screens.
DRO mode screen
The DRO screen shows:
 Feature list of measured features on the left side
 Unit of measure and current datum in the upper right corner
 The current positions of all axes
 Part alignment status: a small rectangle over the axis letter indicates
that the part is aligned to a measurement axis (a skew was
performed)
Notice
Installation and setup screens and soft keys are described
later in Chapter 2: Installation, Setup and Specifications.
DRO current position screen showing current axis
positions