HEIDENHAIN ND 100 User Manual - Manual (Page 21)

ND 120 QUADRA-CHEK 21
1
.2 Basic F
unctions
Panel key descriptions
Descriptions of panel key functions are provided in the following
pages for Measurement function, Command, Help, Axis, Send and Menu
keys. Soft key functions are also described later in the next section as
part of screen and soft key layout descriptions.
ND 123 panel keys
MEASURE keys Function
Measure point: Press the Point key once to
measure one point, or twice to use auto
repeat to measure a series of points. A
minimum of one data point is required to
measure a point.
Measure line: Press the Line key once to
measure one line, or twice to use auto repeat
to measure a series of lines. A minimum of
two data points are required to measure a
line.
Measure circle: Press the Circle key once to
measure one circle, or twice to use auto
repeat to measure a series of circles. A
minimum of three data points are required to
measure a circle.
Measure distance: Press the Distance key
once to measure one distance, or twice to
use auto repeat to measure a series of
distances. Two points are required to
measure a distance.
Measure angle: Press the Angle key once to
measure one angle, or twice to use auto
repeat to measure a series of angles. Collect
a minimum of two data points, then press the
ENTER
key on each leg of an angle.
Align part: Press the Skew key to
compensate electronically for non-square
part alignment on the primary axis.