HEIDENHAIN ND 100 User Manual - Manual (Page 38)

38 1 Operation
1
.4 Measur
ing P
a
rt
F
eat
ur
es
Measuring points
Points are the simplest features to measure. Only one point is required
to define the location of a point. A maximum of 100 points can be
probed and will be averaged by the system to measure a single point.
 Press the Point Measurement key. The Probe Point
screen will be displayed. Press the key twice to
measure a series of points using auto repeat.
 Move the stage to position the crosshairs over the
desired point location and press the ENTER key.
 Press the FINISH key to complete the measurement.
The point position will be shown and the point feature
will be added to the feature list.
A point is probed on the part
The point position is shown and the point feature is
added to the feature list