HEIDENHAIN ND 100 User Manual - Manual (Page 102)

102 2 Installation and Specifications
2
.2
S
o
ft
wa
re
s
e
tu
p The functions contained in the Special menu are shown here:
Special menu function Description
Annot Toggles between forward and backward annotation probing
Clear Clears the feature list, skews and datums
DMS/DD Toggles the display of angles between degrees, minutes and seconds and decimal degrees.
Inch/mm Toggles the display of linear units of measure between inches and millimeters.
MCS Clears datums and reestablishes machine coordinates.
MinMax Displays the maximum and minimum encoder count on the selected axis. An absolute range
(from the minimum to maximum) is displayed as well.
Preset Presets datums to user specified values that correspond to known part coordinates such as
dimensions specified by a part drawing.
Preset! Repeats the last preset datum performed.
Prt RS Sends data for the current print request to the USB-to-Serial connection
Ref 1/2 Toggles the datum being used between datum 1 and datum 2.
Send 2, 3 Sends the current X-Y, X-Y-Z or X-Y-Q axes data to a computer.
Send D Sends the current diameter data to a computer.
Send F Sends the current form error data to a computer.
Send L Sends the current length data to a computer.
Send Q Sends the current protractor Q-axis data to a computer.
Send r Sends the current radius data to a computer.
Send X Sends the current X-axis data to a computer.
Send Y Sends the current Y-axis data to a computer.
Send Z Sends the current Z-axis data to a computer.
Send < Sends the current angle measurement data to a computer.
Zero 2 Zeroes the X and Y axes
Zero Q Zeroes the Q-axis