HEIDENHAIN ND 100 User Manual - Manual (Page 46)

46 1 Operation
1
.6 Constr
ucting P
a
rt
F
eat
ur
es
Example of constructing a feature
In this example, a new point feature is constructed from two parent
circle features:
 Press the Point Measurement key.
 Press the Constr soft key or press the Up Arrow key to highlight the
last feature in the feature list. If the last feature in the feature list will
not be one of the parent features, press the Up Arrow key until the
first parent feature is highlighted. In this example, the first parent
circle feature is at the bottom of the feature list.
 Press the ENTER key to select the highlighted feature. A checkmark
will appear at the feature location in the list.
 Continue highlighting and then selecting features until all the
required parent features are selected. In this example, the second
circle feature is highlighted and selected.
 Press the FINISH key to construct the new feature. The new point
feature is shown at the bottom of the feature list.
Point Measurement key is pressed First circle feature is highlighted First circle feature is selected as a parent
feature
Second circle feature is highlighted Second circle feature is selected as a
parent feature FINISH key is pressed to complete
constructing the new point feature