HEIDENHAIN ND 100 User Manual - Manual (Page 47)

ND 120 QUADRA-CHEK 47
1
.6 Constr
ucting P
a
rt
F
eat
ur
es
 Press the View soft key to show a graphic image of the feature
construction. In this example the image shows that the Int 1 point
feature was constructed at the top intersection of the two circle
circumferences.
 Press the Change soft key to show alternative point features that can
be constructed from the two parent circle features.
 Press the desired construction alternative soft key to change the
feature construction type. In this example, the Mid Pt point feature
was selected, and the point is constructed at the mid point between
the two circle center points.
More feature construction examples
A collection of some typical feature constructions are shown here
graphically as examples. Many more constructions are possible.
Invalid construction requests will initiate an error message.
View soft key is pressed to show graphic
image of constructed feature
Change soft key is pressed to show
alternative constructions
Point feature type is changed from Int 1
to Mid Pt
Construction Parent features Graphic
Point Two lines: intersection
Point Line and circle: intersection
Point Two circles: intersection
Point Two points: mid point