Grass Valley NV9601 v.2.0 - Manual (Page 53)

NV9601 Control Panel • User’s Guide 43
6. Operation
Locks
3 If not already in Source Mode, press
Src Mode
. All buttons associated with source selection light
in green.
4 Press
Lock
.
How to release a locked source in X-Y or MD mode
1 Press
XY/MD
to place the panel in X-Y mode.
2 Select the device being released:
a Press
Src Mode
. All buttons associated with destination selection light in green.
b Press the desired category button (see Category and Keypad Buttons on page 13). The cate-
gory appears in Column 1.
c From the display area, select a device by pressing the
Page Up
and
Page Down
buttons. A
flag appears next to the device in the ‘Lev/Dest’ column.
Or
Using the keypad, enter the device’s index number (see
Category and Keypad Buttons on
page 13). The Index number appears in Column 1.
3 If the lock was set by the current user:
• If it appears in the ‘Status’ column, press Src and then press Lock .
• If it appears in the ‘Preset’ column, press Src and then press Prst Rls .
If the lock was set by another user, the Force Release function must be enabled to perform a
release (see
Force Release on page 39).
Locking and Unlocking Destinations
How a destination is locked depends on whether you are in X-Y or MD mode. Only the user that
applied the lock can remove it unless Forced Release mode has been enabled (see
Force Release on
page 39). Once locked, no sources can be switched to the locked destination until the destination is
unlocked.
When a lock is applied to a destination, a ‘L’ appears next to the device in the ‘Lev/Dest’ column.
How to lock a destination in X-Y or MD mode
1 Press
XY/MD
to place the panel in X-Y or MD mode.
2 If needed, select a destination device:
a Press
Dst Mode
. All buttons associated with destination selection light in amber.
b Press the desired category button (see Category and Keypad Buttons on page 13). The cate-
gory appears in Column 1.
c From the display area, select a device by pressing the
Page Up
and
Page Down
buttons. A
flag appears next to the device in the ‘Lev/Dest’ column.
Or
Using the keypad, enter the device’s index number (see
Category and Keypad Buttons on
page 13). The Index number appears in Column 1.
3 Press ‘Dst Lock’ to lock the destination device.