Grass Valley NV9601 v.2.0 - Manual (Page 44)

34 Rev 2.0 • 29 Mar 09
6. Operation
Broadcast Mode
How to perform a breakaway
1 Press
XY/MD
to place the panel in X-Y mode. The panel buttons turn green.
2 Select the desired destination device (If already selected, go to Step 3):
a Press
Dst Mode
. All buttons associated with destination selection light in amber.
b Press the desired ‘Category’ button (see Category and Keypad Buttons on page 13). The
category appears in Column 1.
c Select a device. Press
Scroll
and then
Page Up
or
Page Down
to scroll through the list of
devices by index number or using the keypad, enter the device’s index number (see Cate-
gory and Keypad Buttons on page 13).
The index number for the device appears in the ‘Dest’ field in Column 1. The levels
associated with that device appear in the ‘Lev/Dest’ column:
3 Preset the desired source:
a Press
Src Mode
. All buttons associated with source selection light in green.
b From the display area, select select those levels you want included in the “take” by pressing
the corresponding selection button (see Selection Buttons on page 12). A flag appears next
to the level in the ‘Lev/Dest’ column. By default, all levels are included unless deselected.
Selection buttons are toggles: press to select; press again to deselect.
c Press the desired category button (see Category and Keypad Buttons on page 13). The cate-
gory appears in Column 1.
d Select a device. Press
Scroll
and then
Page Up
or
Page Down
to scroll through the list of
devices by index number or using the keypad, enter the device’s index number (see Cate-
gory and Keypad Buttons on page 13).
The index number for the device appears in Column 1. The levels associated with that
device appear in the ‘Lev/Dest’ column.
4 (Optional) To retain the subset of levels selected, press
Hold
. After the “take” is performed only
the levels selected in Step 4 remain flagged rather than defaulting to all valid levels being
flagged.
5 Press
Take
. The source(s) in the ‘Preset’ column are routed to the destination(s) listed in Col-
umn 1. The ‘Preset’ and ‘Status’ columns update to reflect the route, as shown in Figure 6-2 on
page 51.
Broadcast Mode
Broadcast mode (default legend Brd cst ) is only available in X-Y mode. The control panel must
have
Brd cst
,
Src Mstr
and
Save Prst
buttons present in order to perform this function.
This mode is used to assign a “master” device and connect it to multiple “slave” devices. In this
manner, a broadcast route is created. A data (control) router is required for this route. For example,
Note Remember that the current destination appears in Column 1, the source that is
routed to that destination appears in the ‘Status’ column, and the destination’s
associated levels appear in the ‘Lev/Dest’ column.
Press
Clear
at any time to undo your last selection.