Grass Valley NV9601 v.2.0 - Manual (Page 39)

NV9601 Control Panel • User’s Guide 29
4. Installation
Verification
Verification
A panel test/verification function is available when the NV9601 is disconnected from the system
controller. Use it to determine the health of your NV9601.
How to test panel functions
1 Disconnect the panel from the Ethernet, but keep connected to power. After approximately 30
or 40 seconds, a single button lights on the panel.
2 Press the button. ‘Firmware Menu’ appears in the display area.
3 Press selection button
3 for ‘Test’ (see Selection Buttons on page 12). The display area auto-
matically lights up to show that all points are illuminating correctly.
4 Perform the following:
a A single button lights. Press the button. All buttons should light up in green, low tally.
b Press the same button again. All buttons should light up in green, high tally.
c Press the same button again. All buttons should light up in amber, low tally.
d Press the same button again. All buttons should light up in amber, high tally.
e Press the same button again. The ‘Firmware Menu’ appears.
f Press the same button again to exit the ‘Firmware Menu’.
5 Reconnect the Ethernet cable. Within a few seconds the system controller detects the control
panel.
Note In this procedure, the control panel is disconnected from the network, but con-
nected to power.