Grass Valley JSC-2300 SHOT - Manual (Page 51)

Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual 51
Recall Camera Presets
Figure 35. Enter Preset Dialog Box
3. In the PRESET box, type the camera number to preset.
Note In the following step, the 0 (default) setting is equal to the maximum robotics
speed (refer to the respective camera manual).
4. In the SPEED box, type the speed (in seconds) for the change from
current position to the preset position.
5. Click STORE .
Note Each SHOT Director controller can store up to 300 preset positions for each
camera.
6. Repeat Step 1 through Step 5 for each camera preset.
Recall Camera Presets
1. Select a camera (refer to Camera Selection on page 50 ).
2. On the Camera and Preset keypad, press PRESET . The ENTER PRESET
dialog box ( Figure 35 ) appears.
3. In the PRESET box, type the preset number to recall.
Note In the following step, the preset speed can be over-ridden any time by typing
a new speed in the SPEED box first.
4. Click RECALL.
Manual Camera Control
Focus Control
1. Select a camera (refer to Camera Selection on page 50 ).
8 4 9 3_
sc00_r0