Grass Valley JSC-2300 SHOT - Manual (Page 49)

Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual 49
Section
4
Operation
Note For a description of SHOT Director™ controls, indicators, and dialog box
functions, refer to
Controls and Indicators on page 21 .
Note To make selections and enter information, the following procedures use the
Camera and Preset keypad with the joystick as a pointing device and joystick
top button as a mouse-type left click. Instead of using the joystick, the
MANUAL IRIS and FOCUS CONTROL knobs can also be used during setup to
select various setup parameters.
Operation consists of:
• Power On/Off on page 49
• Camera Selection on page 50
• Camera Presets Assignment on page 50
• Recall Camera Presets on page 51
• Manual Camera Control on page 51
Power On/Off
Power On
Note For more information on powering up other devices on the network, see the
operation manual that came with the device.
1. Ensure that one camera is connected and powered on. Refer to Connect
to Network on page 38 .
Note The first time the JSC-2300 SHOT Director controller powers on, the joystick
calibration dialog box (
Figure 28 ) appears. After the initial calibration, every
time the SHOT Director controller powers on, the CAMERA CONTROL Home
dialog box (
Figure 13 ) appears. If the Center Joystick calibration dialog box
appears in the following step, refer to Calibrate Joystick on page 39 .