Grass Valley JSC-2300 SHOT - Manual (Page 38)

38 Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual
Section 3 — Installation and Setup
Install SHOT Director Controller
Unpack
Check all parts received against the packing list enclosed with your ship-
ment, and examine the equipment for any shipping damage. Immediately
report any missing or damaged items to the carrier and to your Grass
Valley Service Representative (See Contacting Grass Valley
on page 4 ).
Keep all manuals supplied with your equipment. You will need them to
complete the installation procedures.
Connect to Network
Note A 10/100 Base TX auto-sensing Ethernet hub is required to connect a JSC-
2300 SHOT Director controller to multiple Ignite SDC/HDC robotic cameras.
Note All SHOT Director controllers and SDC/HDC cameras are preset to default IP
and subnet addresses at the factory to enable the SHOT Director controller
and one camera to establish communication immediately on the network. In
order to connect a second camera, you must change the IP address of the
first camera before connecting the next, then repeat this process until all
cameras are uniquely addressed.
1. For:
• Multiple camera operation, connect an Ethernet cable between the
10/100 MBIT ETHERNET connector on the rear panel of the SHOT
Director controller and the network hub.
• Single camera operation, connect an Ethernet crossover cable
between the 10/100 MBIT ETHERNET connector on the rear panel
of the SHOT Director controller and the Ethernet connector on the
rear of the Pan/Tilt head.
2. Refer to the Ignite SDC/HDC Robotic Camera Instruction Manual for
installing and connecting a camera to the network.
Connect Power Supply
Using the provided power supply, connect the dc (direct current) plug to
the SHOT Director controller 5 V dc input on the rear panel (
Figure 11 );
plug the other end into a standard ac wall outlet.