Grass Valley JSC-2300 SHOT - Manual (Page 47)

Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual 47
Setup SDC/HDC Robotic Camera
Note Pan/Tilt soft stops can be adjusted individually to compensate for mounting
location obstructions or installation of a prompter. Refer to the Ignite SDC/
HDC Robotic Camera Instruction Manual for further details concerning soft
stops settings.
1. Press the Setup button ( Figure 8 ). The MAIN SETUP MENU dialog box
( Figure 15 ) appears.
2. From the MAIN SETUP MENU dialog box ( Figure 15 ), select PAN/TILT
SETTINGS . The PAN/TILT SETTINGS dialog box ( Figure 16 ) appears.
3. From the PAN/TILT SETTINGS dialog box ( Figure 16 ), select SOFTSTOPS
SETUP . The PAN/TILT SOFTSTOPS dialog box ( Figure 17 ) appears.
Note Previously saved User soft stops will display as a checked box. If no User soft
stops exist, all boxes will be unchecked.
4. Select POINTER to change the joystick to a pointing device.
5. Uncheck the U (up), D (down), L (left), and/or R (right) check box(s) for
the softstops being changed.
6. Select JOY to change the joystick to motion device.
7. Using the joystick, pan or tilt the camera to the desired soft stop
position.
In the example below ( Figure 33 ), the up (U) soft stop is selected
(unchecked) to set or change. The Tilt position display shows Tilt(U).23 .
Figure 33. Pan/Tilt Soft Stop Example
8. Ensure the Pan or Tilt position display shows the desired direction ( U ,
D , L , R ) of the soft stop being set or changed.
9. When the desired position and direction is displayed in the dialog box,
check the desired soft stop checkbox to acknowledge the position
coordinates.
10. Repeat Step 5 through Step 9 to change any of the other soft stops, then
select SAVE to save all checked soft stop positions.