Grass Valley JSC-2300 SHOT - Manual (Page 44)

44 Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual
Section 3 — Installation and Setup
3. Select IP ADDRESS TABLE ( Figure 16 ). The PAN/TILT IP TABLE dialog box
( Figure 18 ) appears.
CAUTION Do not change the default CAM:16 IP address. This is the default factory
address assigned to all new SDC/HDC camera Pan/Tilt heads. The initial
network communication required to setup and operate a new camera will not
be possible.
Note The currently selected camera and IP address are highlighted in the Pan/Tilt
IP address table.
4. Using the joystick, select the camera ID/IP address to modify. The
selected camera ID/IP address automatically fill the edit address boxes
below the table.
5. Use the joystick to select, then modify the IP address box(s).
Note Repeat Step 4 and Step 5 for each camera ID/IP address that needs modified.
6. Select SAVE to save the changes to the table.
Note If necessary, reset the Pan/Tilt IP Address table to factory defaults listed in
Table 2 by selecting DFLT from the PAN/TILT IP TABLE dialog box, then
selecting SAVE.
Setup SDC/HDC Robotic Camera
Set Camera ID and IP Address
Note Each SDC/HDC camera pan/tilt head is factory pre-configured with the
defaults:
If your system consists of multiple cameras, you must change the camera
IP address for the first camera to CAM1, and then each successive camera
added to the network to CAM2, CAM3, etc. using the IP addresses listed in
Table 2 .
Note Each camera must be connected to the network and assigned a unique IP
address and camera identification number prior to connecting any additional
cameras.
Head IP: 192.168.0.126 Corresponds to camera 16 IP address
Subnet Mask: 255.255.255.0
Controller IP: 192.168.0.100 Corresponds to the SHOT Director controller IP address