Grass Valley JSC-2300 SHOT - Manual (Page 45)

Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual 45
Setup SDC/HDC Robotic Camera
Table 2. Camera ID and IP Address
If your system consists of a single camera, changing the camera IP address
to CAM1 is recommended.
1. Press the Setup button ( Figure 8 ). The MAIN SETUP MENU dialog box
( Figure 15 ) appears. At the bottom of the dialog box, verify the camera
status is CAM: 16 - STATUS: ONLINE .
2. From the MAIN SETUP MENU dialog box ( Figure 15 ), select PAN/TILT
SETTINGS . The PAN/TILT SETTINGS dialog box ( Figure 16 ) appears.
3. From the PAN/TILT SETTINGS dialog box ( Figure 16 ), select PAN/TILT IP
ADDRESS . The PAN/TILT IP ADDRESS dialog box ( Figure 18 ) appears.
4. Select any of the IP field boxes and change them to the desired camera
ID and IP address shown in Table 2 .
Note Ensure SUBNET is set to 255.255.255.0 and CA matches the SHOT Director
default IP address (192.168.0.100)
5. Select SET to send the new IP , SUBNET , and CA addresses to the Pan/Tilt
head.
6. From the CONFIRM dialog box ( Figure 32 ), select YES to save the new IP ,
SUBNET , and CA addresses to the Pan/Tilt head.
Camera
Number
Related IP Address
CAM1 192.168.0.111
CAM2 192.168.0.112
CAM3 192.168.0.113
CAM4 192.168.0.114
CAM5 192.168.0.115
CAM6 192.168.0.116
CAM7 192.168.0.117
CAM8 192.168.0.118
CAM9 192.168.0.119
CAM10 192.168.0.120
CAM11 192.168.0.121
CAM12 192.168.0.122
CAM13 192.168.0.123
CAM14 192.168.0.124
CAM15 192.168.0.125
CAM16 192.168.0.126 (default)