Grass Valley JSC-2300 SHOT - Manual (Page 39)

Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual 39
Setup SHOT Director Controller
Setup SHOT Director Controller
Power On
1. Ensure that one camera is connected and powered on. Refer to Connect
to Network on page 38 .
Note For more information on powering up other devices on the network, see the
operation manual that came with the device.
2. Press the Power button ( Figure 5 ). The Power indicator illuminates.
Note The first time the JSC-2300 SHOT Director controller powers on, the joystick
calibration dialog box (
Figure 27 ) appears. After this initial calibration, every
time the SHOT Director controller powers on, the CAMERA CONTROL home
dialog box (
Figure 13 ) appears.
• The Grass Valley splash dialog box ( Figure 12 ) appears briefly
and then the Center Joystick Then Press Enter dialog box ( Figure 27 )
appears.
Adjust LCD Dialog Box
• If necessary, adjust the LCD CONTRAST and LCD BACKLIGHT on the rear
panel ( Figure 11 ) of the SHOT Director controller to obtain the best
LCD clarity.
Figure 27. Joystick Calibration Dialog Box 1
Calibrate Joystick
Note The first time the JSC-2300 SHOT Director controller powers on, the joystick
calibration dialog box (
Figure 27 ) appears. After this initial calibration, every
time the SHOT Director controller powers on, the CAMERA CONTROL home
dialog box (
Figure 13 ) appears.
8 4 9 3_
sc01_r0