Grass Valley JSC-2300 SHOT - Manual (Page 41)

Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual 41
Setup SHOT Director Controller
5. Using the joystick, navigate to and then click OK to complete the
calibration. The CAMERA CONTROL Home dialog box ( Figure 13 ) appears.
6. Check default operation between the SHOT Director controller and the
camera.
a. Press the CAMERA button ( Figure 10 ). The CAMERA Select dialog box
( Figure 31 ) appears.
Figure 31. Camera Select Dialog Box
b. Using the joystick, select the CAMERA box, type 16, and then press the
enter button ( Figure 10 ). The CAMERA CONTROL Home dialog box
( Figure 13 ) now indicates Camera 16 in the top right corner and the
Pan , Tilt , Zoom , Focus , and Iris values change as the joystick, zoom
control, focus knob, and iris knob are rotated.
Verify Controls
Note Do not attempt to control a robotic camera until proper operation of SHOT
Director controls is verified.
1. Press the Setup button ( Figure 8 ). The MAIN SETUP MENU dialog box
( Figure 15 ) appears.
2. Select DIAG ( Figure 15 ). The DIAGNOSTICS dialog box ( Figure 26 ) appears
and the AUTO IRIS indicator blinks continuously.
3. Center the joystick, then verify that the first three sets of numbers in the
second row of
RAW POT VALUES are greater than -30 and less than 30. If
the values are outside this range, perform a manual joystick calibration
(refer to
Calibrate Joystick on page 39 ).
4. Move the ZOOM and PAN/TILT SPEED CONTROL sliders from one end of
travel to the other end of travel. Verify that the fourth and fifth set of
RAW POT VALUES read 0 (±2) to 50 (±2) as the sliders are moved. If the
values are outside this range, perform a manual joystick calibration
(refer to
Calibrate Joystick on page 39 ).
5. Rotate the FOCUS CONTROL knob and verify that it operates smoothly for
several rotations in each direction. Verify that the FOCUS numerical
display on the DIAGNOSTICS dialog box changes with the rotation of the
knob.
8 4 9 3_
sc00_r0