Grass Valley JSC-2300 SHOT - Manual (Page 43)

Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual 43
Setup SHOT Director Controller
3. Press the CAMERA button ( Figure 10 ). The CAMERA select dialog box
( Figure 31 ) appears.
4. Using the joystick, select the CAMERA box ( Figure 31 ), type the number
of the camera to assign to the Camera Quick Select button, and then
press the
enter button ( Figure 10 ). The CAMERA CONTROL Home dialog
box ( Figure 13 ) now indicates the selected camera in the top right
corner.
5. Press and hold the Camera Quick Select button ( Figure 8 ) until the
newly assigned camera number appears in the box above the Quick
Select button (
Figure 13 ).
Reset SHOT Director Defaults (Optional)
1. Press the Setup button ( Figure 8 ). The MAIN SETUP MENU dialog box
( Figure 15 ) appears.
2. Select SHOTDIRECTOR SETTINGS ( Figure 15 ). The SHOT DIRECTOR SETTINGS
dialog box ( Figure 21 ) appears.
3. Select SET DEFAULT ( Figure 21 ). The SELECT DEFAULT SETTINGS dialog box
( Figure 25 ) appears.
4. With the joystick, select (check or uncheck) any of the selection boxes
for
PAN DIRECTION , TILT DIRECTION , SD IP ADDRESS , BEEP , HOT KEYS , or DEL
PRESET .
Change Pan/Tilt IP Table Entries (Optional)
CAUTION Do not change the default CAM:16 IP address. This is the default factory
address assigned to all new SDC/HDC camera Pan/Tilt heads. The initial
network communication required to setup and operate a new camera will not
be possible.
Note Although not recommended, the IP Table can be modified if the default IP
addresses are already assigned to other network devices. Check with your
Network Administrator for assignment of valid IP addresses to use in this
table.
Note If you change the Pan/Tilt IP Address table, the addresses listed in Table 2
will not be valid.
1. Press the Setup button ( Figure 8 ). The MAIN SETUP MENU dialog box
( Figure 15 ) appears.
2. Select PAN/TILT SETTINGS ( Figure 15 ). The PAN/TILT SETTINGS dialog box
( Figure 16 ) appears.