Grass Valley JSC-2300 SHOT - Manual (Page 40)

40 Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual
Section 3 — Installation and Setup
Note To access joystick calibration at any time after initial calibration, while pow-
ering on the SHOT Director controller, press and hold the Setup button
(
Figure 8 ), until the Zeroing Joystick Please Wait dialog box appears.
1. Ensure that the joystick is in the center position, then press the enter
button ( Figure 10 ). The Zeroing Joystick Please Wait dialog box ( Figure 28 )
appears for approximately 5 seconds.
CAUTION When Zeroing Joystick Please Wait dialog box appears, Do not touch the
Joystick. The Zeroing Joystick Please Wait dialog box displays approxi-
mately 5 seconds.
Figure 28. Zeroing Joystick Dialog Box
2. When the zero calibration process finishes, the Levels dialog box
(
Figure 29 ) appears.
Figure 29. Levels Dialog Box
3. Move the joystick control and the sliders to their extreme positions so
the SHOT Director controller can record minimum and maximum
levels. When finished, press the
enter button ( Figure 10 ). The CALIBRATE
JOYSTICK dialog box ( Figure 30 ) appears.
Figure 30. Joystick Calibration Dialog Box 4
4. Using the joystick, check that the pointer reaches all four corners of the
screen. If not, repeat the joystick calibration by pressing the
enter button
( Figure 10 ).
8 4 9 3_
sc02_r0
8 4 9 3_03_r0
8 4 9 3_
sc04_r0