Grass Valley JSC-2300 SHOT - Manual (Page 42)

42 Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual
Section 3 — Installation and Setup
6. Rotate the MANUAL IRIS knob and verify that it operates smoothly for
several rotations in each direction. Verify that the IRIS numerical
display on the DIAGNOSTICS dialog box changes with the rotation of the
knob.
Note The following step refers to the grid in the lower left corner of the DIAGNOS-
TICS dialog box.
7. Verify that a corresponding box highlights when pressing:
• Each button on the controller (except the Power button)
• The button on top of the joystick
8. Select OK .
Set Audible Alarm (Optional)
Note By default, the audible alarm (BEEP) is set to ON (checked box) with the pitch
set to 20 (mid-range).
1. Press the Setup button ( Figure 8 ). The MAIN SETUP MENU dialog box
( Figure 15 ) appears.
2. Select SHOTDIRECTOR SETTINGS ( Figure 15 ). The SHOT DIRECTOR SETTINGS
dialog box ( Figure 21 ) appears.
3. To turn off the audible alarm, use the joystick to uncheck the BEEP
checkbox ( Figure 21 ).
4. To change the BEEP pitch, use the joystick to select the pitch box
( Figure 21 ), type in a number from 0 to 40, and press the keypad enter
button ( Figure 10 ).
5. Select OK .
Reassign Camera Quick Select Buttons (Optional)
Note By default, Camera Quick Select buttons ( Figure 8 ) are set to CAM1 through
CAM4. There are only four Quick Select buttons, so assign them to the four
most frequently used cameras.
1. Press the Home button ( Figure 8 ). The CAMERA CONTROL Home dialog box
( Figure 13 ) appears.
2. To erase the current camera entry, press and hold any Camera Quick
Select buttons (
Figure 8 ) for three seconds.