Grass Valley JSC-2300 SHOT - Manual (Page 46)

46 Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual
Section 3 — Installation and Setup
Figure 32. Confirm Dialog Box
7. Reboot (power down/up) the Pan/Tilt head for the new IP , SUBNET , and
CA addresses to take effect.
8. P ress the Home button ( Figure 8 ). The CAMERA CONTROL Home dialog box
( Figure 13 ) appears.
9. From the keypad, press the CAMERA button. The CAMERA dialog box
( Figure 31 ) appears.
10. Using the joystick, select the CAMERA box. In the Camera box, type the
number of the camera that was just modified.
11. On the Camera and Preset keypad, press enter . The CAMERA CONTROL
Home dialog box ( Figure 13 ) now indicates Camera # (the number of the
camera modified) in the top right corner.
12. Repeat process for each camera (one at a time).
Set Pan and Tilt Orientation
Note The SHOT Director controller pan and/or tilt operation can be reversed, if nec-
essary, to compensate for inverted camera mounting and/or operator loca-
tion in relation to the camera. Refer to
PAN and TILT Orientation on page 33 .
1. Press the Setup button ( Figure 8 ). The MAIN SETUP MENU dialog box
( Figure 15 ) appears.
2. From the MAIN SETUP MENU dialog box ( Figure 15 ), select SHOTDIRECTOR
SETTINGS . The SHOTDIRECTOR SETTINGS dialog box ( Figure 21 ) appears.
3. From the SHOTDIRECTOR SETTINGS dialog box ( Figure 21 ), select (check
the box) for REVERSE PAN and/or REVERSE TILT as necessary.
Set Pan/Tilt Soft Stops
Note Pan/Tilt soft stops are camera specific and are stored in the Pan/Tilt head.
Factory defaults are ±178° for both Pan and Tilt.
8 4 9 3_
sc15_r0