Grass Valley 3050 CopperHead - Manual (Page 63)

57
CopperHead 3050
User Guide
DIAG/REV A quick push of the Display Mode Selector advances to
the Power (POWR) diagnostic sub-mode. This sub-mode
displays the microcontroller firmware revision of every
board in the Base Station that has a microcontroller.
Note: the REV versions noted here were current as of
August 1, 2010. Your system may have different REV
versions
DIAG/REV REV Initial display of REV after Display Mode Selector being
advances
DIAG/REV DISP Indicates the Display microcontroller board is revision is
being queried
DIAG/REV REV Indicates that sub-mode is REV
DIAG/REV REVC Indicates that the REV for the DISP board is REVC
DIAG/REV VBS Indicates the VBS microcontroller board is revision is
being queried
DIAG/REV REV Indicates that sub-mode is REV
DIAG/REV REVA Indicates that the REV for the VBS board is REVA
DIAG/REV BASE Indicates the Base Station main microcontroller board is
revision is being queried
DIAG/REV REV Indicates that sub-mode is REV
DIAG/REV REVA Indicates that the REV for the BASE board is REVA
DIAG/REV AUD Indicates the audio microcontroller board is revision is
being queried
DIAG/REV REV Indicates that sub-mode is REV
DIAG/REV REVA Indicates that the REV for the AUD board is REVA
DIAG/REV PS Indicates the power supply microcontroller board is
revision is being queried
DIAG/REV REV Indicates that sub-mode is REV
DIAG/REV REVD Indicates that the REV for the DISP board is REVD
This display cycle repeats until the Display Mode Selector
is pushed
DIAGNOSTIC MODE Camera Unit Error Status (CAM)
A quick push of the Display Mode Selector advances to the Camera Unit (CAM) diagnostic sub-
mode. This mode displays the error status of the Camera Unit. The Digital Display Characters are
Green if Camera Unit shows no error and Red if the Camera Unit does have an error. This is a high-
level view of the Camera Unit error status. For further information go to the Camera Unit
diagnostic display.
DIAG/CAM CAM Indicates that the sub-mode is CAM
DIAG/CAM OK Indicates that the Camera Unit is reporting No fault
DIAG/CAM ERR Indicates that the Camera Unit is reporting Some fault
This display cycle repeats until the Display Mode Selector
is pushed
Display Mode Readout Base Station Digital Display Activity Explanation