Ation, see, Set up of the, Copperhead 3050 transceiver system for operation – Grass Valley 3050 CopperHead User Manual
Page 54
48
Operation of the System
Set Up of the CopperHead 3050 Transceiver System for operation
Set Up of the CopperHead 3050 Transceiver System for operation
This section explainshow to setup the CopperHead 3050 Transceiver System for operation.
It is important that you do an initial setup and test your CopperHead 3050 Transceiver
System as soon as your receive in order to confirm proper operation.You also need to
provide training prior to an actual production.
Use the following list of items as an overall checklist for setup.
• It is highly recommended that you do not attempt to power up the system until all
connections are made and in particular the Fiber Optic Cable has been connected at
both ends. If you need to power up either the CopperHead 3050 Base Station or
Camera Unit, make sure that the Fiber Connectors are securely capped. This will protect
them from damage or dirt and protect you from eye damage.
• If it is the first time setting up the CopperHead 3050 Base Station, or your setup is not
permanent (in a remote truck, stadium control room or similar), connect all required
cables according to
Connections to the CopperHead 3050 Base Station
on page 40. The
order in which you connect the cables makes no difference.
• Make sure to connect the Camera Remote Control cable to the Base Station and
Remote Control Panel when the Base Station power is turned off.
• Keep Fiber Optic cable connectors capped until actually connecting the Fiber
Cable.
• When setting up the CopperHead 3050 Camera Unit and associated Camera, you must
do the following:
• If your unit is so configured, setup the external power supply as required. For the
MPS power supply used with the CopperHead 3050 Power Wafer, see
on page 30. Make sure all cables running between the
CopperHead 3050 Base Station and the Power Supply and local AC power cords are
properly managed and secured.
• Mount the Camera and CopperHead 3050 Camera Unit (see
CopperHead 3050 Camera Unit to the Camera
• Connect all required cables according to
Connections to the CopperHead 3050
on page 43. The order in which you connect the cables makes no
difference.
• Set up the Intercom Talk Back switches and level controls as desired (see
Understanding Intercom Usage with the CopperHead 3050
• Deploy the Fiber Cable.
You should read the Using Fiber Optics Guide for information on how to manage and
deploy your fiber optics cabling, safety precautions, tips & tricks, and recommendations
for creating complex fiber optic networks. You can find a copy of this document on the
Support portal (see
• You are now ready to Power Up the system (see