Grass Valley 3050 CopperHead User Manual
Page 47
41
CopperHead 3050
User Guide
5
Ethernet Connector – 10Bt/100Bt capable
Designed to carry IP traffic data between the Base Station and the Camera
Unit. A laptop PC or other device such as a Wireless Access Point can be
connected to the Production Environment IP network.
6
VBS Out
BNC Connector -Typically used for SD Monitoring Video return from the
Camera
7
VBS In
BNC Connector – Typically used to send SD return video to the camera – an
example is monitor out from the Production Switcher
8
SDI Out 1 & 2 (this carries the HD feed from the camera)
BNC Connectors – Two identical video feeds from the camera – typically one
may be used for local HD monitoring and one is fed to the Production
Switcher environment.
9
SDI In
BNC Connector – Typically used to send HD return video to the camera – an
example is program out from the Production Switcher
10 & 11
Intercom Connectors #1 & #2
XLR 3 pin or 5 pin Connector depending on configuration. One of three
options will be installed (4-wire intercom, RTS or Clear-Com).
12
Audio In- Multi-Pin Connector
DB25 – 25 pin Connector follows the Tascam TDIF standard. The
CopperHead 3050 Transceiver System
accommodates up to two Audio
Channels at Line Level. This connector handles return audio to the Camera
location as well as intercom Program Audio. See
13
Audio Out- Multi-Pin Connector
DB25 – 25 pin Connector follows the Tascam TDIF standard. The
CopperHead 3050 Transceiver System
accommodates up to two Audio
Channels at Line Level. This connector handles Program audio from the
Camera location. See
Multi-Pin Connectors: Suggested Wiring
on page 72 for
sample wiring.
15
12V Terminal Block
Terminal Block – bare wire connector. This can be used in place of the ADAP
power connection in installations that have 12V power distributed as part of
their infrastructure. Do not use this at the same time as the ADAP power
connection.
Diagram # Description