Grass Valley 3050 CopperHead - Manual (Page 43)

37
CopperHead 3050
User Guide
Between the Base Station (1) the Camera Unit (2), connect a length of Tactical Fiber Cable
(3). At each end of the fiber cable, there is either an OpticalCON (4) or MX Fiber Connector
(5).
The Base Station connector (4) may be mounted either on the front or back of the Base
Station. The camera must be powered by local power, either a Battery or a local AC Power
Supply (6).
PowerWafer Scenarios #1 and #2
• PowerWafer Scenario #1: Hybrid Fiber direct between Powered Base Station and
Camera Unit on page 37
• PowerWafer Scenario #2: Infrastrucure Copper & Fiber between Powered Base Station
and Camera Unit on page 37
Hybrid Fiber direct between Powered Base Station and Camera Unit
Fig. 5-2: SMPTE Hybrid Fiber between the Base Station (powered) and Camera Unit
Between the Base Station (1) and the Camera Unit (2) connect a length of SMPTE Hybrid
Fiber Cable (3). At each end of the fiber cable,there is either an OpticalCON or SMPTE 304M
Connector (4) and (5).
The Base Station connector (4) may be mounted either on the front or back of the Base
Station. The camera will be powered by the
CopperHead Power Wafer Camera Power Supply
(6).
Infrastrucure Copper & Fiber between Powered Base Station and Camera
Unit
Infrastructure Wiring Built-In to a Facility using OpticalCON Connectors
Note: Your configuration may have the OpticalCON or MX Fiber
Connector directly mounted on the Base Station Chassis.