Grass Valley 3050 CopperHead - Manual (Page 46)

40
Connection of the System
Connections to the CopperHead 3050 Base Station
Connections to the CopperHead 3050 Base Station
Fig. 5-5: CopperHead 3050 Base Unit Connections
Multi-pin cable assemblies used with the CopperHead 3050 Base Station:
• A - Audio In Connector: Connect Intercom Program Audio and IFB Intercom Audio (see
Base Station 25-Pin Audio Input Cable on page 73).
• B - Audio Out Connector: Carries audio back from the camera location - connect to an
audio processing chain or monitors (see Base Station 25-Pin Audio Output Cable on
page 74).
Connectors into and out of the CopperHead 3050 Base Station
This information duplicates some of that from above sections. It is presented here to
provide a single list of all Base Station connections. Key numbers refer to the diagram above
and to the Overview Diagram found in
Diagrams on page 82.
Diagram # Description
1 & 14 Power In
Connect a standard 12V DC ADAP power source (4 Pin) or a standard 3
conductor AC Cable (IEC Plug) 100-240V 50/60 Hz
4 Fiber Connector
This connector can be mounted on the Base Station Front Panel (see
Relocation of the CopperHead 3050 Base Station Fiber connector on
page 34).
Connect the fiber connector from either the Fiber Cable connected directly
to the camera or from the external power unit designated for your system.
The type of Fiber Connector will vary depending on your system
configuration.