Grass Valley Aurora Playout v.6.3 - Manual (Page 48)

48 Aurora Playout User Guide September 2007
Chapter 4 Configuring Aurora Playout
Configuring GPI Output
To assign the function of a GPI output, select the channel it affects, the command in
Aurora Playout that triggers GPI output and the GPI output number.
Click the Summary button to see an overview of the current GPI settings.
Setting Options Description
Enable GPI Output On (checked)
Off (unchecked)
Check Enable GPI Output to allow Aurora Playout to
trigger GPI outputs.
Channel
Channel A - F Select the channel that will trigger the GPI output.
Command Cued The output is set when the channel is cued; reset when the
channel is playing or if the clip is ejected.
Playing The output is set when the channel is playing; reset when
the channel is stopped or the clip is ejected.
Loop Play The output is set when the channel is in loop play mode;
reset if not in loop play mode.
Jog Forward The output is set when the Jog Forward or Jog Backward
buttons are pressed; reset when the Play, Stop, or Eject
buttons are pressed, or when the channel is re-cued.
Jog Backward
End Blip 1 (Hold till End
of Clip) The output is set when the playing channel reaches End
Blip 1; reset when the channel is stopped or the clip is
ejected.
End Blip 2 (Hold till End
of Clip) The output is set when the playing channel reaches End
Blip 2; reset when the channel is stopped or the clip is
ejected.
GPI Output
1-16 or 1-32 (depending
on your configuration)
Select the GPI output you want to activate.