Grass Valley Aurora Ingest v.6.3 User Manual
Page 56
56
Aurora Ingest System Guide
September 2007
Chapter 2 Installing and Configuring Aurora Ingest
users could see and select all available channels within the dropdown list.
11. From the list of available VTRs, select the VTR router source. Once selected, the
router source is displayed in the Selected VTR box.
12. You can also check the Enable RS-422 Switching box and select the RS-422
destination.
13. To make the changes but keep the Options dialog box open, click
Apply
.
14. Proceed to configure video viewer in the Video Viewer tab.
NOTE: If you have the optional Hauppage WinTVGo video capture card or
Blackmagic Design DeckLink video capture card installed in your VTR Ingest
machine, you will need to define the destination of the router connected (via digital to
analog converters, if needed) to your video capture card.
15. Click the Video Viewer tab.
16. Check the 16:9 format video if desired.
17. Select the router destination from the dropdown list. If no router has been
configured, this field will be grayed out. To configure a router, see
.
18. For the Capture Device dropdown list, select No Capture Device if you want to
view the asset via a separate video monitor.
19. If you have installed a video capture card, select the device in the capture device
dropdown list.
20. Click OK after you are done with the configuration.
The VTR Ingest application is now ready for use. For more information, see
.