Grass Valley Aurora Ingest v.6.3 - Manual (Page 104)

104 Aurora Ingest System Guide September 2007
Chapter 5 Using VTR Ingest
Channel Window Toolbar
The Toolbar lets you perform common functions for recording clips:
Channel Columns
Each channel window displays information about the clips in the segment (batch) list:
VTR Ingest Overview
To record clips from a VTR, follow these basic steps:
1. Decide if you want to add handles to your clips.
2. Create a segment list or import an EDL.
3. Record the segment list to your Media Server.
Icon Function
Displays channel status—A green icon indicates status is OK; a red
icon indicates a problem. Click on this icon to see status for the VTR,
Primary Server, and Backup Server.
Deletes the selected clip(s).
Clears the segment (batch) capture list.
Organize the segment (batch) capture list firstly by tape IDs, and
then by mark in points.
Move up the selected clip in the capture list.
Move down the selected clip in the capture list.
Move segments within the same tape up in the capture list.
Move segments within the same tape down in the capture list.
Column Description
Title The name of the clip.
Clip Location The name of the folder where the clip resides in the media server.
Duration The duration of the clip.
Mark In The mark points for the clip.
Mark Out
Time Source Control track (CTLTRACK), LTC, or VITC. Note: if using CTL, clip will not
be frame accurate, instead it will be +/- 10 frames.
Owner The name of the person who marked the clip
Tape ID The identification of the particular tape
Error Message Any error messages describing why the clip was not recorded to the server.
Use Handles Indicate whether handles have been added to the clip.