Grass Valley Aurora Ingest v.6.3 - Manual (Page 107)

September 2007 Aurora Ingest System Guide 107
Marking In and Out Points
Marking In and Out Points
Mark points are used to determine the length of a clip.
To set Mark In and Out Points:
1. Find the spot on the videotape where you want your clip to begin.
2. Mark an In Point using any of the following methods:
• Press I on your keyboard.
• Click the Mark In button on the Aurora Ingest window.
• Type the timecode in the In field.
• Create a Mark In on the VTR.
3. Play through the tape until you reach the point where you want the clip to end.
4. Mark an Out Point using any of these methods:
• Press O on your keyboard.
• Click the Mark Out button on the Aurora Ingest window.
• Use the up or down arrows to find the correct timecode.
• Type the ending timecode in the Out field.
• Create a Mark Out on the VTR.
Recording Clips to the Media Server
After you’ve created a segment (batch) list, you can record the clips to your media
server.If you are recording to SD channels of K2 version 3.2, you can also set the clip
aspect ratio in the clip record area of VTR Ingest.The option to switch aspect ratio is
set in the System tab within
Tools|Options of Aurora Ingest - Server and it depends on
the user administration setup of your ingest operation.
To record:
1. Make sure the Channel Window is selected.
Sets a
Mark In
Point
Sets a
Mark Out
Point Clears
Mark In
Point
Clears
Mark Out
Point
Shows
Duration
Moves to
Mark In
Point
Moves to
Mark Out
Point of Clip
Shows
Remaining
Time of Clip
Adds Handles
to the Clip Adds the Clip to
the Segment List