Grass Valley Aurora Ingest v.6.3 - Manual (Page 52)

52 Aurora Ingest System Guide September 2007
Chapter 2 Installing and Configuring Aurora Ingest
and records on VTR Ingest will be triggered with timecode detection via RS-422.
NOTE: Records with RS-422 timecode mode have a frame accuracy recording
window of +/- 10 frames. Due to this, in and out handle settings are provided within
the setup.
5. You can set In and Out Handles for recordings with VTR using the RS-422
timecode mode. Both handles are set to 10 frames by default.
6. If you are using an XDCAM VTR, you can select the checkbox to enable auto scan
for the XDCAM VTR. The XDCAM VTR does not adhere to typical RS-422
shuttle commands. By enabling the auto scan feature for XDCAM VTR, previous
and next commands will be used instead of the usual shuttle forward and back.
7. You can also change the shuttle speed for the auto scan feature. The default is set
to 32, but you can change to any value depending on the type of VTR that you use.
When XDCAM mode is selected, the field to set the shuttle speed of auto scan will
be disabled and grayed out.
8. Click OK to add the VTR.