H3C Technologies H3C S10500 Series Switches User Manual

Page 76

# Configure the mode of VFC 1 as E.

[SwitchA-Vfc1] fc mode e

# Bind VFC 1 to interface Ten-GigabitEthernet 1/0/1.

[SwitchA-Vfc1] bind interface ten-gigabitethernet 1/0/1

# Assign VFC 1 to VSAN 1 as a trunk port.

[SwitchA-Vfc1] port trunk vsan 1

[SwitchA-Vfc1] quit

# Configure Ten-GigabitEthernet 1/0/1 as a trunk port, and assign the port to VLAN 10.

[SwitchA] interface ten-gigabitethernet 1/0/1

[SwitchA-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchA-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10

[SwitchA-Ten-GigabitEthernet1/0/1] quit

# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1.

[SwitchA] vlan 10

[SwitchA-vlan10] fcoe enable vsan 1

[SwitchA-vlan10] quit

# Configure two static routes.

[SwitchA] vsan 1

[SwitchA-vsan1] fc route-static 020000 8 vfc 1

[SwitchA-vsan1] fc route-static 030000 8 vfc 1

Configure Switch B
# Configure the switch to operate in advanced mode, save the configuration, and reboot the

switch. (Skip this step if the switch is operating in advanced mode.)

system-view

[SwitchB] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

[SwitchB] save

[SwitchB] quit

reboot

# Configure the switch to operate in FCF mode.

system-view

[SwitchB] fcoe-mode fcf

# Enable the fabric configuration feature for VSAN 1.

[SwitchB] vsan 1

[SwitchB-vsan1] domain configure enable

# Set the domain ID to 2.

[SwitchB-vsan1] domain-id 2 static

[SwitchB-vsan1] quit

# Create interface VFC 1.

[SwitchB] interface vfc 1

# Configure the mode of VFC 1 as E.

[SwitchB-Vfc1] fc mode e

# Bind VFC 1 to interface Ten-GigabitEthernet 1/0/1.

This manual is related to the following products: