H3C Technologies H3C S10500 Series Switches - Manual (Page 56)

45
Fabric building configuration examples
Static fabric building configuration example
Network requirements
As shown in Figure 19 , use the static method to build a fabric.
Figure 19 Network diagram
Configuration procedure
This section describes only the fabric building configurations.
1. Configure Switch A:
# Configure the switch to operate in advanced mode, save the configuration, and reboot the
switch. (Skip this step if the switch is operating in advanced mode.)
system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
[SwitchA] save
[SwitchA] quit
reboot
# Configure the switch to operate in FCF mode, and disable the fabric configuration feature in
VSAN 1.
system-view
[SwitchA] fcoe-mode fcf
[SwitchA] vsan 1
[SwitchA-vsan1] undo domain configure enable
# Configure a fabric name.
[SwitchA-vsan1] fabric-name 11:11:11:11:11:11:11:11
# Set the domain ID to 1.
[SwitchA-vsan1] domain-id 1 static
Non-disruptive reconfiguration or isolating the switch may be performed. Continue?
[Y/N]:y
[SwitchA-vsan1] quit
# Create interface VFC 1, and configure it to operate in F mode.
[SwitchA] interface vfc 1
[SwitchA-Vfc1] fc mode f
# Bind VFC 1 to interface Ten-GigabitEthernet 1/0/1, and assign VFC 1 to VSAN 1 as a trunk
port.
[SwitchA-Vfc1] bind interface ten-gigabitethernet1/0/1