H3C Technologies H3C S10500 Series Switches - Manual (Page 148)

137
# Bind VFC 10 to Layer 2 aggregate interface 1.
[SwitchA-Vfc10] bind interface bridge-aggregation 1
# Assign VFC 10 to VSAN 100 as a trunk port.
[SwitchA-Vfc10] port trunk vsan 100
# Enable FSPF for VFC 10.
[SwitchA-Vfc10] undo fspf silent vsan 100
[SwitchA-Vfc10] quit
# Enable FCoE for VLAN 4001 and map VLAN 4001 to VSAN 100.
[SwitchA] vlan 4001
[SwitchA-vlan4001] fcoe enable vsan 100
[SwitchA-vlan4001] quit
# Enter the view of VSAN 100, and configure the members in the default zone to access each
other.
[SwitchA] vsan 100
[SwitchA-vsan100] zone default-zone permit
[SwitchA-vsan100] quit
Configuring Switch B
Configure Switch B in a similar way Switch A is configured, with the following differences:
• The aggregate interface configured on Switch A is Layer 2 aggregate interface 1.
• The aggregate interface configured on Switch B is Layer 2 aggregate interface 2.
Configuring Switch C
1. Configure the switch to operate in advanced mode, save the configuration, and reboot the switch.
(Skip this step if the switch is operating in advanced mode.)
system-view
[SwitchC] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the system
to make it effective.
[SwitchC] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
Slot 1:
Save next configuration file successfully.
[SwitchC] quit
reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
Current configuration will be lost after the reboot, save current configuration?
[Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait...