H3C Technologies H3C S10500 Series Switches - Manual (Page 125)

114
FCS configuration example
Network requirements
As shown in Figure 32 , start a topology discovery to obtain topology information in the fabric for the
management application.
Figure 32 Network diagram
Configuration procedure
This section describes only FCS configurations.
# Configure the switch to operate in advanced mode, save the configuration, and reboot the switch.
(Skip this step if the switch is operating in advanced mode.)
system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
[SwitchA] save
[SwitchA] quit
reboot
# Configure the switch to operate in FCF mode.
system-view
[SwitchA] fcoe-mode fcf
# Start a topology discovery in VSAN 1 on Switch A.
[SwitchA] fcs discovery start vsan 1
Verifying the configuration
# Display the FCS database information in VSAN 1 on Switch A.
[SwitchA] display fcs database vsan 1
FCS Local Database in VSAN 1:
IE WWN : 10:00:00:11:22:00:01:01
Domain ID : 0x01
Management address list : snmp://192.168.0.1