H3C Technologies H3C S10500 Series Switches - Manual (Page 40)

29
Figure 17 Network diagram
Configuration procedure
This section describes only the VSAN configurations.
1. Configure Switch A:
# Configure the switch to operate in advanced mode, save the configuration, and reboot the
switch. (Skip this step if the switch is operating in advanced mode.)
system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
[SwitchA] save
[SwitchA] quit
reboot
# Configure the switch to operate in FCF mode.
system-view
[SwitchA] fcoe-mode fcf
# Create VSAN 10 and VSAN 20.
[SwitchA] vsan 10
[SwitchA-vsan10] quit
[SwitchA] vsan 20
[SwitchA-vsan20] quit
# Create interface VFC 1.
[SwitchA] interface vfc 1
# Configure the mode of VFC 1 as F.
[SwitchA-Vfc1] fc mode f
# Bind VFC 1 to interface Ten-GigabitEthernet 1/0/1.
[SwitchA-Vfc1] bind interface
ten-gigabitethernet 1/0/1
# Assign VFC 1 to VSAN 10 as a trunk port.