Requirements analysis, Configuration procedure – H3C Technologies H3C S10500 Series Switches User Manual
Page 102
91
Figure 27 Network diagram
Requirements analysis
To meet the network requirements, divide VSAN 1 into three zones as follows:
•
Assign Server A to Zone 1.
•
Assign Server B and Disks A, B, and C to Zone 2.
•
Assign Server C and Disks B and C to Zone 3.
•
Enable Pairwise for Zone 2, configure Server B as an initiator, and configure Disks A, B, and C as
targets.
•
Enable Pairwise for Zone 3, configure Server C as an initiator, and configure Disks B and C as
targets.
•
Create zone alias Alias 1, which contains Disks B and C, to simplify the configuration.
•
Create zone set Zoneset 1, which contains Zones 1, 2, and 3, and activate it.
Configuration procedure
This section describes only FC zone configurations on Switch A. You do not need to configure FC zones
on Switch B.
# Configure the switch to operate in advanced mode, save the configuration, and reboot the switch.
(Skip this step if the switch is operating in advanced mode.)
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
[SwitchA] save
[SwitchA] quit