H3C Technologies H3C S10500 Series Switches User Manual
Page 203
192
[SwitchA-vlan100] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 10.1.1.1 255.255.255.0
[SwitchA-Vlan-interface100] quit
# Configure interface VLAN-interface 101, the physical interface of the tunnel.
[SwitchA] vlan 101
[SwitchA-vlan101] port GigabitEthernet 1/0/2
[SwitchA-vlan101] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 address 2002::1:1 64
[SwitchA-Vlan-interface101] quit
# Create service loopback group 1, and configure the service type as tunnel.
[SwitchA] service-loopback group 1 type tunnel
# Add port GigabitEthernet 1/0/3 to service loopback group 1, and disable STP and LLDP on the port.
[SwitchA] interface GigabitEthernet 1/0/3
[SwitchA-GigabitEthernet1/0/3] undo stp enable
[SwitchA-GigabitEthernet1/0/3] undo lldp enable
[SwitchA-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchA-GigabitEthernet1/0/3] quit
# Create a tunnel interface Tunnel 0.
[SwitchA] interface tunnel 0
# Configure an IPv4 address for interface Tunnel 0.
[SwitchA-Tunnel0] ip address 10.1.2.1 255.255.255.0
# Configure the tunnel encapsulation mode as GRE over IPv6.
[SwitchA-Tunnel0] tunnel-protocol gre ipv6
# Configure the source address of interface Tunnel 0 to be the IP address of interface VLAN-interface
101.
[SwitchA-Tunnel0] source 2002::1:1
# Configure the destination address of interface Tunnel 0 to be the IP address of interface VLAN-interface
101 on Switch B.
[SwitchA-Tunnel0] destination 2001::2:1
# Apply service loopback group 1 to the tunnel in tunnel interface view.
[SwitchA-Tunnel0] service-loopback-group 1
[SwitchA-Tunnel0] quit
# Configure a static route from Switch A through interface Tunnel 0 to Group 2.
[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 0
2.
Configure Switch B
# Enable IPv6.
[SwitchB] ipv6
# Configure interface VLAN-interface 100.
[SwitchB] vlan 100
[SwitchB-vlan100] port GigabitEthernet 1/0/1
[SwitchB-vlan100] quit