H3C Technologies H3C S10500 Series Switches - Manual (Page 153)

142
Figure 60 Network diagram of dynamic domain name resolution
Configuration procedure
NOTE:
•
Before performing the following configuration, make sure that the device and the host are accessible to
each other via available routes, and the IPv6 addresses of the interfaces are configured as shown
Figure
60 .
• This configuration may vary with DNS servers. The following configuration is performed on a PC
running Windows Server 2003. Make sure that the DNS server supports the IPv6 DNS function so that
the server can process IPv6 DNS packets, and the interfaces of the DNS server can forward IPv6
packets.
1. Configure the DNS server
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
As shown in
Figure 61 , right click Forward Lookup Zones, select New zone, and then follow the
instructions to create a new zone named com.
Figure 61 Create a zone
# Create a mapping between the host name and the IPv6 address.
As shown in
Figure 62 , right click zone com.