H3C Technologies H3C S10500 Series Switches User Manual
Page 189
178
[SwitchA-Vlan-interface101] quit
# Create service loopback group 1 to support the tunnel service.
[SwitchA] service-loopback group 1 type tunnel
# Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP and LLDP on the
interface.
[SwitchA] interface GigabitEthernet 1/0/3
[SwitchA-GigabitEthernet1/0/3] undo stp enable
[SwitchA-GigabitEthernet1/0/3] undo lldp enable
[SwitchA-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchA-GigabitEthernet1/0/3] quit
# Create interface Tunnel 1.
[SwitchA] interface tunnel 1
# Configure an IPv6 address for interface Tunnel 1.
[SwitchA-Tunnel1] ipv6 address 3001::1:1 64
# Configure the tunnel encapsulation mode.
[SwitchA-Tunnel1] tunnel-protocol ipv6-ipv6
# Configure the source address for interface Tunnel 1 (IP address of VLAN-interface 101).
[SwitchA-Tunnel1] source 2002:11::1
# Configure the destination address for interface Tunnel 1 (IP address of VLAN-interface 101 of Switch
B).
[SwitchA-Tunnel1] destination 2002::22:1
# Reference service loopback group 1 on the tunnel.
[SwitchA-Tunnel1] service-loopback-group 1
[SwitchA-Tunnel1] quit
# Configure a static route from Switch A through interface Tunnel 1 to Group 2.
[SwitchA] ipv6 route-static 2002:3:: 64 tunnel 1
•
Configuration on Switch B
# Enable IPv6.
[SwitchB] ipv6
# Configure an IPv6 address for VLAN-interface 100.
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ipv6 address 2002:3::1 64
[SwitchB-Vlan-interface100] quit
# Configure an IPv6 address for VLAN-interface 101 (the physical interface of the tunnel).
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ipv6 address 2002::22:1 64
[SwitchB-Vlan-interface101] quit
# Create service loopback group 1 to support the tunnel service.
[SwitchB] service-loopback group 1 type tunnel
# Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP and LLDP on the
interface.
[SwitchB] interface GigabitEthernet 1/0/3