H3C Technologies H3C S10500 Series Switches - Manual (Page 126)

115
Parameters Description
Prefix Information
options After receiving the prefix information, the hosts on the same link can perform
stateless autoconfiguration.
MTU Ensure that all nodes on a link use the same MTU value.
M flag
Determines whether hosts use the stateful autoconfiguration to acquire IPv6
addresses.
If the M flag is set to 1, hosts use the stateful autoconfiguration (for example, through
a DHCP server) to acquire IPv6 addresses. Otherwise, hosts use the stateless
autoconfiguration to acquire IPv6 addresses and generate IPv6 addresses
according to their own link-layer addresses and the obtained prefix information.
O flag
Determines whether hosts use stateful autoconfiguration to acquire other
configuration information.
If the O flag is set to 1, hosts use stateful autoconfiguration (for example, through a
DHCP server) to acquire other configuration information. Otherwise, hosts use
stateless autoconfiguration to acquire other configuration information.
Router Lifetime Tells the receiving hosts how long the advertising device can live
Retrans Timer
If the device fails to receive a response message within the specified time after
sending an NS message, it will retransmit the NS message.
Reachable Time
If the neighbor reachability detection shows that a neighbor is reachable, the
device considers the neighbor reachable within the specified reachable time. If the
device must send a packet to the neighbor after the specified reachable time
expires, the device will reconfirm whether the neighbor is reachable.
Follow these steps to allow sending of RA messages:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Disable RA message
suppression
undo ipv6 nd ra halt
Required
By default, RA messages are suppressed.
Configure the maximum
and minimum intervals
for sending RA
messages
ipv6 nd ra interval
max-interval-value
min-interval-value
Optional
By default, the maximum interval for sending
RA messages is 600 seconds, and the
minimum interval is 200 seconds.
The device sends RA messages at random
intervals between the maximum interval and
the minimum interval.
The minimum interval should be less than or
equal to 0.75 times the maximum interval.
Follow these steps to configure parameters related to RA messages:
To do… Use the command… Remarks
Enter system view system-view —
Configure the hop limit ipv6 nd hop-limit value
Optional
64 by default.