H3C Technologies H3C S10500 Series Switches - Manual (Page 134)

123
Figure 49 Network diagram for IPv6 address configuration
NOTE:
The VLAN interfaces have been created on the switch.
Configuration procedure
1. Configure Switch A
# Enable IPv6.
system-view
[SwitchA] ipv6
# Specify a global unicast address for VLAN-interface 2.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address 3001::1/64
[SwitchA-Vlan-interface2] quit
# Specify a global unicast address for VLAN-interface 1, and allow it to advertise RA messages (no
interface advertises RA messages by default).
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] ipv6 address 2001::1/64
[SwitchA-Vlan-interface1] undo ipv6 nd ra halt
[SwitchA-Vlan-interface1] quit
2. Configure Switch B
# Enable IPv6.
system-view
[SwitchB] ipv6
# Configure a global unicast address for VLAN-interface 2.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address 3001::2/64
[SwitchB-Vlan-interface2] quit
# Configure an IPv6 static route with destination IP address 2001::/64 and next hop address 3001::1.
[SwitchB] ipv6 route-static 2001:: 64 3001::1
3. Configure the host
# Enable IPv6 for Host to automatically obtain an IPv6 address through IPv6 ND.
# Display the neighbor information of GigabitEthernet 1/0/2 on Switch A.
[SwitchA] display ipv6 neighbors interface GigabitEthernet 1/0/2
Type: S-Static D-Dynamic
IPv6 Address Link-layer VID Interface State T Age
FE80::215:E9FF:FEA6:7D14 0015-e9a6-7d14 1 GE1/0/2 STALE D 1238
2001::15B:E0EA:3524:E791 0015-e9a6-7d14 1 GE1/0/2 STALE D 1248
The output shows that the IPv6 global unicast address that the host obtained is
2001::15B:E0EA:3524:E791.