H3C Technologies H3C S12500 Series Switches - Manual (Page 84)

73
• Device A, Device B, Device C, and Device D form RRPP domain 1. Specify the primary control VLAN
of RRPP domain 1 as VLAN 4092, and specify that RRPP domain 1 protects VLANs 1 through 30.
• Device A, Device B, Device C and Device D form primary ring 1.
Specify Device A as the master node of primary ring 1, GigabitEthernet 3/0/1 as the primary port and
GigabitEthernet 3/0/2 as the secondary port.
Specify Device B, Device C and Device D as the transit nodes of primary ring 1, their GigabitEthernet
3/0/1 as the primary port and GigabitEthernet 3/0/2 as the secondary port.
Figure 18 Network diagram
Configuration procedure
1. Configure Device A:
# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region
configuration.
system-view
[DeviceA] vlan 1 to 30
[DeviceA] stp region-configuration
[DeviceA-mst-region] instance 1 vlan 1 to 30
[DeviceA-mst-region] active region-configuration
[DeviceA-mst-region] quit
# Set the physical state change suppression interval to 0 seconds on GigabitEthernet 3/0/1 and
GigabitEthernet 3/0/2, disable the spanning tree feature, configure the two ports as trunk ports,
and assign them to VLANs 1 through 30.
system-view
[DeviceA] interface gigabitethernet 3/0/1
[DeviceA-GigabitEthernet3/0/1] link-delay 0
[DeviceA-GigabitEthernet3/0/1] undo stp enable
[DeviceA-GigabitEthernet3/0/1] port link-type trunk
[DeviceA-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30
[DeviceA-GigabitEthernet3/0/1] quit
[DeviceA] interface gigabitethernet 3/0/2
[DeviceA-GigabitEthernet3/0/2] link-delay 0
[DeviceA-GigabitEthernet3/0/2] undo stp enable