H3C Technologies H3C S12500 Series Switches - Manual (Page 119)

108
Step Command Remarks
2. Enter MST region view. stp region-configuration
For more information about the
command, see Layer 2—LAN
Switching Command Reference.
3. Configure the
VLAN-to-instance mapping
table.
• Method 1:
instance instance-id vlan
vlan-list
• Method 2:
vlan-mapping modulo modulo
Optional.
Use either method.
All VLANs in an MST region are
mapped to MSTI 0 by default.
For more information about the
instance and vlan-mapping
modulo commands, see Layer
2—LAN Switching Command
Reference.
4. Activate MST region
configuration manually.
active region-configuration
For more information about the
command, see Layer 2—LAN
Switching Command Reference.
5. Display the currently activated
configuration information of
the MST region.
display stp region-configuration [ |
{ begin | exclude | include }
regular-expression ]
Optional.
This command is available in any
view.
For more information about the
command, see Layer 2—LAN
Switching Command Reference.
6. Return to system view. quit N/A
7. Create a smart link group and
enter smart link group view.
smart-link group group-id N/A
8. Configure protected VLANs
for the smart link group.
protected-vlan reference-instance
instance-id-list By default, no protected VLAN is
configured for a smart link group.
Configuring member ports for a Smart Link group
You can configure member ports for a smart link group either in smart link group view or in interface view.
The configurations made in these two views have the same effect.
In smart link group view
To configure member ports for a smart link group in smart link group view:
Step Command
1. Enter system view. system-view
2. Create a smart link group and enter smart link
group view.
smart-link group group-id
3. Configure member ports for a smart link group. port interface-type interface-number { master | slave }
In interface view
To configure member ports for a smart link group in interface view: