H3C Technologies H3C S12500 Series Switches User Manual
Page 194
183
# Configure VLAN 2.
[SwitchA] vlan 2
[SwitchA-vlan2] port Gigabitethernet 3/0/5
[SwitchA-vlan2] quit
# Configure VRRP to operate in load balancing mode.
[SwitchA] vrrp mode load-balance
# Create VRRP group 1 and configure its virtual IPv6 addresses as FE80::10 and 1::10.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address fe80::1 link-local
[SwitchA-Vlan-interface2] ipv6 address 1::1 64
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10
# Set the priority of Switch A in VRRP group 1 to 120, which is higher than that of Switch B (110)
and that of Switch C (100), so that Switch A can become the master.
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 priority 120
# Configure Switch A to operate in preemptive mode so that it can become the master whenever
it works correctly; configure the preemption delay as 5 seconds to avoid frequent status
switchover.
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay 5
# Enable Switch A to send RA messages so that hosts on network segment 1::/64 can learn the
default gateway address.
[SwitchA-Vlan-interface2] undo ipv6 nd ra halt
[SwitchA-Vlan-interface2] quit
# Create track entry 1 to associate with the physical status of VLAN-interface 3 on Switch A. When
the track entry becomes negative, it means that the interface fails.
[SwitchA] track 1 interface vlan-interface 3
# Configure VF tracking to monitor track entry 1 and specify the value by which the weight
decreases, making the weight of Switch A decrease by more than 245 (250 in this example) when
track entry 1 turns to negative. In such a case, another router with a higher weight can take over.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 weight track 1 reduced 250
2.
Configure Switch B:
# Configure VLAN 2.
[SwitchB] vlan 2
[SwitchB-vlan2] port Gigabitethernet 3/0/5
[SwitchB-vlan2] quit
# Configure VRRP to operate in load balancing mode.
[SwitchB] vrrp mode load-balance
# Create VRRP group 1 and configure its virtual IPv6 addresses as FE80::10 and 1::10.
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address fe80::2 link-local
[SwitchB-Vlan-interface2] ipv6 address 1::2 64
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10