H3C Technologies H3C S12500 Series Switches - Manual (Page 113)

102
[DeviceD-GigabitEthernet3/0/1] port link-type trunk
[DeviceD-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30
[DeviceD-GigabitEthernet3/0/1] quit
[DeviceD] interface gigabitethernet 3/0/2
[DeviceD-GigabitEthernet3/0/2] link-delay 0
[DeviceD-GigabitEthernet3/0/2] undo stp enable
[DeviceD-GigabitEthernet3/0/2] port link-type trunk
[DeviceD-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30
[DeviceD-GigabitEthernet3/0/2] quit
# Create RRPP domain 1, configure VLAN 4092 as the primary VLAN of RPPP domain 1, and
configure the VLANs mapped to MSTI 1 as the protected VLANs of RRPP domain 1.
[DeviceD] rrpp domain 1
[DeviceD-rrpp-domain1] control-vlan 4092
[DeviceD-rrpp-domain1] protected-vlan reference-instance 1
# Configure Device D as a transit node of the primary ring Ring 1, with GigabitEthernet 3/0/1 as
the primary port and GigabitEthernet 3/0/2 as the secondary port, and enable Ring 1.
[DeviceD-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet 3/0/1
secondary-port gigabitethernet 3/0/2 level 0
[DeviceD-rrpp-domain1] ring 1 enable
[DeviceD-rrpp-domain1] quit
# Enable the RRPP protocol.
[DeviceD] rrpp enable
5. Verify the configuration.
Use the display command to view RRPP configuration and operational information on Device A
and Device D.
Troubleshooting RRPP
Symptom
When the link state is normal, the master node cannot receive Hello packets, and the master node
unblocks the secondary port.
Analysis
The reasons can be the following:
• RRPP is not enabled on some nodes in the RRPP ring.
• The domain ID or primary control VLAN ID is not the same for the nodes in the RRPP ring.
• Some ports are abnormal.
Solution
• Use the display rrpp brief command to check whether RRPP is enabled for all nodes. If not, use the
rrpp enable command and the ring enable command to enable RRPP and RRPP rings for all nodes.
• Use the display rrpp brief command to check whether the domain ID and primary control VLAN ID
are the same for all nodes. If not, set the same domain ID and primary control VLAN ID for the
nodes.
• Use the display rrpp verbose command to check the link state of each port in each ring.