H3C Technologies H3C S12500 Series Switches User Manual
Page 60
49
# Enable DLDP globally, configure Gigabitethernet 2/0/1 and Gigabitethernet 2/0/2 to operate
in full duplex mode, and then enable DLDP on the two ports.
[DeviceB] dldp enable
[DeviceB] interface gigabitethernet 2/0/1
[DeviceB-Gigabitethernet2/0/1] duplex full
[DeviceB-Gigabitethernet2/0/1] speed 1000
[DeviceB-Gigabitethernet2/0/1] dldp enable
[DeviceB-Gigabitethernet2/0/1] quit
[DeviceB] interface gigabitethernet 2/0/2
[DeviceB-Gigabitethernet2/0/2] duplex full
[DeviceB-Gigabitethernet2/0/2] speed 1000
[DeviceB-Gigabitethernet2/0/2] dldp enable
[DeviceB-Gigabitethernet2/0/2] quit
# Set the DLDP mode to enhanced.
[DeviceB] dldp work-mode enhance
# Set the port shutdown mode to auto.
[DeviceB] dldp unidirectional-shutdown auto
3.
Verify the configuration:
After the configurations are complete, you can use the display dldp command to display the DLDP
configuration information on ports.
# Display the DLDP configuration information on all the DLDP-enabled ports of Device A.
[DeviceA] display dldp
DLDP global status : enable
DLDP interval : 5s
DLDP work-mode : enhance
DLDP authentication-mode : none
DLDP unidirectional-shutdown : auto
DLDP delaydown-timer : 1s
The number of enabled ports is 2.
Interface Gigabitethernet2/0/1
DLDP port state : advertisement
DLDP link state : up
The neighbor number of the port is 1.
Neighbor mac address : 0023-8956-3600
Neighbor port index : 59
Neighbor state : two way
Neighbor aged time : 11
Interface Gigabitethernet2/0/2
DLDP port state : advertisement
DLDP link state : up
The neighbor number of the port is 1.
Neighbor mac address : 0023-8956-3600
Neighbor port index : 60
Neighbor state : two way