17 dome setting / dome control – ARM Electronics CMS User Manual
Page 95
User’s Manual
94
7.17
Dome Setting / Dome Control
Userss can also set/control the dome camera in CMS. Right click on the
channel where a dome camera is properly installed. Refer to the following
picture to see how they look like.
Dome Setting:
Select
dome protocol changed at this interface is only temporary. To permanently
change dome protocol, please modify it in the configuration.
Dome Control:
The function of each button on the
A.F. (Auto Focus)
Click on
to focus the camera automatically.
Set/Go Preset Point
Click on
to set a present point, and
to go to the preset point.
ID
Click on
to setup the Dome ID/Protocol. This function resembles to the
Focus
This is used to manually focus on the objects. Click on the